Hubsan 4CH Mini Invader Helicopter

Rudder central Auto-Trimming : Land your heli on the ground for 3 seconds
and  minimum the throttle, your heli will find the rudder central autonomous.
Alloy rugged construction withstand  from severe crash
Little to do before flight

TX digital station display can be programmed for two types of management: beginner and expert. Within each of these type, it can
be programmed different values of sensitivity for each channel, roll, elevator and rudder. from 0% to 100% in each mode, allow
you to adjust the response sensitivity of the controller to your personal taste, and your level of experience.

Hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder) stick for 1 second to enter the setting status,press
Throttle Trim key up or down  to choose reverse,and then hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder)
stick for 1 second to confirm and exit.

RUDDER SENSITIVITY SET UP- NOR MODE
Hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder)  stick for 1 second to enter the setting status,press
Throttle/Rudder or(mode 1:Elevator/Rudder) key until the three-point dotted line symbol start  to flash(see picture below),
press Rudder Trim to idea sensitivity and then hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder)
stick for 1 second to confirm and exit.

ELEV SENSIVITY SET UP- NOR MODE
Hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder)  stick for 1 second to enter the setting status,press
Throttle/Rudder or(mode 1:Elevator/Rudder) key until the three-point dotted line symbol start  to flash(see picture below),
press Elevator Trim to idea sensitivity and then hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder)
stick for 1 second to confirm and exit.

AILE SENSIVITY SET UP- NOR MODE
Hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder)  stick for 1 second to enter the setting status,press
Throttle/Rudder or(mode 1:Elevator/Rudder) key until the three-point dotted line symbol start  to flash(see picture below),
press Aileron Trim to idea sensitivity and then hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder)
stick for 1 second to confirm and exit.

Can fly indoors and outdoors with a slight breeze, Can be set to go nearly as easy as a coaxial, and also to have
much more flexibility and movement control for a quick flight and sport

Size:230L*80H*40Wmm
Flying Weight:60g
Flying Time:Around 8 minutes
Power system:N30 main motor*1,N20 tail rotor*1
Transmitter:4 Channels 2.4Ghz
Servo:super micro size 2.0g 0.12sec/60.
Helicopter battery:3.7V 450mAh LiPo battery with safety PCB.
Transmitter battery:4*AAA(not included)